Do you know how to sew on a button? This is one of the most basic, useful life skills you can have -- and trust me, it isn't rocket science! :)
In this tutorial, I'll show you how to sew on three different kinds of buttons: standard, flat buttons; shanked buttons; and finally, how to add a thread shank to a flat button.
The supplies you need are super basic: a needle and thread, a button, and (of course) some fabric to sew it to! If you want to make a thread shank for your button, you'll also need a matchstick or toothpick.
Thread your needle, and tie a knot at one end. Bring your needle up through the fabric, then sew through one of the holes in the button. Lay the button flat against the fabric, being sure to place it where you want it, and sew down through another hole. (Like I said, this stuff is really complicated!!)
Sew through that same set of holes a couple times, then switch and sew through the other holes. If the button will be getting a lot of use, you should probably sew through each hole 6-8 times; otherwise, 4-5 times should hold it down quite nicely.
Next, let's talk shanks. A shank is a loop on the back of a button, that holds it up from the surface of the fabric. This is great when your button has to go through some thick material -- or for when you don't want a button with holes on the face.
Sewing on a shanked button is almost exactly the same as a flat button. Thread a needle, knot one end, and bring the thread up to the right side of the fabric. Then, run your needle through the shank. Take a tiny "bite" out of the fabric, and pull your thread tight.
Keep stitching in this way (shank, bite of fabric, shank, bite of fabric...) until you've been around a half dozen times, and your button is secure. Run your thread to the backside of the fabric, and tie it off.
But, what about when you have to use a flat button, but need it to stand away from the fabric? Sounds like it's time for a thread shank!
Start sewing this button just like you would a standard flat button -- but before you pull that first stitch tight, slip a matchstick or toothpick between the button and the loop of thread. Pretend the matchstick is just part of the button, and sew around it a half dozen times or so. When the button feels secure, sneak your needle up between the fabric and the button.
Next, wiggle the matchstick out, and pull the button up away from the fabric. Wrap the remaining thread around the little bits of thread between the button and the fabric, then tie your thread off. Ta-da -- you've just made a thread shank!
Thanks for following along today! Do you have a favorite button story? We'd love to hear it!
Yes - I want the Liberty Jane Co. Newsletter!
© 2022 aleksandrajones